MAGX1:

The MAGX1 has an innovative modular design “Plug and Play”; It is a fit-all, flexible, low-cost meter all at the same time. The transmiter consists of the low-cost basic unit plus optional modules according to the end-user’s requirementes. Each modules is in fact a small electronic board, the size of a large stamp, which can be freely installed and removed from the main board in seconds.

MAGX1 features

  • Accuracy 0,25% (0.5 to 10m/s) of reading value
  • Temperature sensor - to measure temperature of the measured medium
  • Voice alarm
  • Graphic display - Multi-language menu. Higher protection via look out systemfor touch buttons and 3 levels of passwords. User, Service, Factory settings
  • Intelligent sensor design – digital communication allows communication between the sensor and the transmitter up to 500m. Calibration data are stored in the sensor communication module. If the transmitter is changed for whatever reason, all the calibration data will be taken from the sensor directly. (for version 7 and higher). No calibration download mistakes.

 

Available downloads:

 

manual • brochure • datasheet • software • software manual • drivers • pictures • Bluetooth installation manual • TCP-IP Installation manual • MODBUS protocol • Technical Procedures • MAGX1 technical training • MAGX1 presentation ENGLISH 9-9-2009

Other features:

  • Graphic display
  • Modbus RTU, can be used with all communication modules
  • BLUETOOTH - You can check your flowmeter from your car. A mobile network is not required
  • TCP/IP module – Intranet use is extremely straightforwad
    with the flowmeter having its own IP- address. With the correct setup, the same module can be used via the internet. All over the world using MAGX1 software is
    possible to connect to the flowmeter via internet.
  • GPRS Wireless communication system which is performed by the GPRS protocol The measurement can be done anywhere in the world You will have your flowmeter under control
  • RS 232 or USB
  • Data downloading and communication does not require disassembly of the housing. No removal of large
    covers or lids is necessary. When using RS485, Bluetooth or GPRS communication, data-downloading and communication is provided with IP67 protection.
  • 3 cable glands for data-output and power supply+ 2 communication slots + 1 main opening for cabling between the sensor and transmitter; all IP67 guaranteed.
  • Universal power supply unit 90-250VAC +/- 10%, 50-60Hz. 24VDC and 12VDC are also available.
  • Three ways to remote mount the transmitter.
    • Wall mounted
    • Panel mounted
    • DIN-rail mounted
  • For remote versions, the cable length between sensor and transmitter can be up to 200m. On request, cable lengths of up to even 500m can be offered.  A small electronic board installed in the sensor makes this
    possible by converting the sensor signal into a digital signal at the sensor.
  • The flow meter will be equipped with an automatic self-diagnostic tool for the sensor. A problem with the communication signal between sensor and transmitter will be reported on the transmitter display.
  • The sensor has automatic temperature compensation.
  • The sensor has indicative temperature measurement.
  • The MagX1 flowmeter has empty pipe detection.